LENCO MARINE Bennett Electric Conversion Kit + Actuator Extension Cable Bennett Retrofit Kit + Cable, 20'

Lenco Marine 15064-001 Bennett Retrofit Kit (12V) upgrades Bennett hydraulic trim tabs to Lenco electric actuators. Lenco Retrofit Kit includes 2 electric actuators, 2 upper mounting brackets, a switch wiring kit, actuator extension cable (20') and all necessary mounting hardware. The kit uses existing Bennett trim planes, lower bracket and switch wiring; upper mounting brackets fit existing Bennett mounting holes allowing straightforward installation without drilling or filling holes. Actuator cable is 14 GA and the kit includes jumper wires and connector plugs to integrate with the existing harness. Also included is the LENCO MARINE 30133-103D 20 ft actuator extension cable (14 GA) to connect trim tab actuators. WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.

• Actuator cable is 14 GA with package dimensions of 7.62 x 19.304 x 12.192 cm.
• Bennett retrofit kit includes jumper wires and connector plugs into existing wire harness for easy installation.
• Also includes LENCO MARINE 30133-103D 20 ft actuator extension cable to connect trim tab actuators.
• Includes LENCO MARINE 15064-001 12-Volt Bennett retrofit kit to upgrade to electric trim tabs (switch kits sold separately).